speedj_rt

This function controls the joint velocity from an external controller in real-time. It allows smooth joint motion control by continuously streaming target velocity and acceleration values through the UDP-based real-time interface.

Definition
DRFLEx.h within class CDRFLEx, public section (line 602)

bool speedj_rt(float fTargetVel[NUM_JOINT],
               float fTargetAcc[NUM_JOINT],
               float fTargetTime) {
    return _speedj_rt(_rbtCtrlUDP, fTargetVel, fTargetAcc, fTargetTime);
};

Parameter

Parameter Name	Data Type	Default Value	Description
fTargetVel	float[6]		Target joint velocity [deg/s] to be commanded.
fTargetAcc	float[6]		Target joint acceleration [deg/s²]. If set to -10000, acceleration is automatically calculated based on fTargetVel.
fTargetTime	float		Duration of target command [s].

Note

• Asynchronous command.

• The motion profile is interpolated to reach (fTargetVel, fTargetAcc) over fTargetTime.

• If fTargetTime ≤ controller cycle (~1 ms), motion is executed without interpolation.

• If the next command is not received before reaching fTargetVel, the previous velocity is maintained.

• If the next command is not received for more than 0.1 s, the system triggers a timeout stop.

• If the global acceleration limit is exceeded, motion stops and an Info message is generated.

Caution

• In the current version, this function is not linked with Operation Speed [%].

• Frequent use with too short intervals may cause communication delay or jerky response.

• Ensure that fTargetTime > communication cycle for stable performance.

Return

Value	Description
1	Success — real-time joint velocity command applied.
0	Error — invalid parameter or communication failure.

Example

#include "DRFLEx.h"
#include <iostream>
#include <cstring>
using namespace DRAFramework;

int main() {
    CDRFLEx drfl;
    drfl.connect_rt_control("192.168.137.100", 12347);

    std::string version = "v1.0";
    float period = 0.001f;  // 1 ms
    int lossCount = 4;

    // RT configuration
    drfl.set_rt_control_input(version, period, lossCount);
    drfl.set_rt_control_output(version, period, lossCount);
    drfl.start_rt_control();

    float fTargetVel[6] = {0.f, 0.f, 0.f, 0.f, 0.f, 0.f};
    float fTargetAcc[6] = {1000.f, 1000.f, 1000.f, 1000.f, 1000.f, 1000.f};
    float fTargetTime = 0.05f; // 50 ms

    float time = 0.f;
    int count = 0;

    while (count++ < 3000) {
        // Example: oscillate J1 between ±50 deg/s
        fTargetVel[0] = 50.f * sin(count * 0.01f);
        drfl.speedj_rt(fTargetVel, fTargetAcc, fTargetTime);
        std::this_thread::sleep_for(std::chrono::milliseconds(1));
    }

    drfl.stop_rt_control();
    drfl.disconnect_rt_control();
    return 0;
}

In this example, the joint velocity is continuously commanded in a sinusoidal profile using speedj_rt at 1 ms intervals.

Tips

• Use speedj_rt for smooth and continuous velocity control of joints.

• Maintain a fixed update loop (typically 1 kHz) for deterministic motion.

• For position-based streaming, use servoj_rt instead.