You're reading the documentation for an older, but still supported version (GL013300).
For information on the latest version, please have a look at GL013301.

CONFIG_DIGITAL_WELDING_INTERFACE_CONDITION

This structure defines the digital interface mapping for welding condition parameters, allowing configuration and monitoring of numeric welding values through digital I/O. It includes job selection, synergic ID, wire feed speed, and dynamic correction parameters.

BYTE#	Field Name	Data Type	Value	Remarks
0	_tJobNumber	CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA		Digital mapping for Job Number Selection
15	_tSynegicID	CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA		Mapping for Synergic ID
30	_tWireFeedSpeed	CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA		Digital mapping for Wire Feed Speed Control
45	_tArclengthCorrection	CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA		Mapping for Arc Length Correction
60	_tDynamicCorrection	CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA		Digital mapping for Dynamic Correction

Total size: 75 bytes

Defined in: DRFS.h

typedef struct _CONFIG_DIGITAL_WELDING_INTERFACE_CONDITION
{
    /* Job number selection mapping */
    CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA _tJobNumber;

    /* Synergic ID mapping */
    CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA _tSynegicID;

    /* Wire feed speed mapping */
    CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA _tWireFeedSpeed;

    /* Arc length correction mapping */
    CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA _tArclengthCorrection;

    /* Dynamic correction mapping */
    CONFIG_DIGITAL_WELDING_IF_MAPPING_DATA _tDynamicCorrection;

} CONFIG_DIGITAL_WELDING_INTERFACE_CONDITION, *LPCONFIG_DIGITAL_WELDING_INTERFACE_CONDITION;

Note

• Used for synchronizing digital signals with welding machine condition settings.

• _tJobNumber allows job-based parameter loading.

• _tDynamicCorrection helps dynamically stabilize the welding arc during process fluctuations.

• Enables programmable control of analog welding parameters over digital communication buses.