You're reading the documentation for an older, but still supported version (GL013300).
For information on the latest version, please have a look at GL013301.

CONFIG_DIGITAL_WELDING_CONDITION

This structure defines all parameter settings for digital welding mode operation, including process type, speed limits, correction factors, and optional extended values. It is used to configure a digital welding controller before execution.

BYTE#	Field Name	Data Type	Value	Remarks
0	_cVirtualWelding	unsigned char	0 or 1	Virtual mode flag (0: Real, 1: Virtual)
1	_fTargetVel	float		Target welding velocity (mm/s)
5	_fMinVelLimit	float		Minimum velocity limit
9	_fMaxVelLimit	float		Maximum velocity limit
13	_nWeldingMode ~ _nWMopt1	unsigned int		Mode options _nWeldingMode: Base process _n2t2tSpecial: 2T/2T special function _nPulseMode: Pulse control _nWMopt1: User-defined welding option
29	_cSimulation	unsigned char	0 or 1	Simulation flag (0: Disabled, 1: Enabled)
30	_cTSopt1, _cTSopt2	unsigned char	0 or 1	Test signal options
32	_nJobNumber ~ _nSynergicID	unsigned int		Job number, Synergic ID
40	_fWireFeedSpeed ~ _fDynamicCorrection	float		Core process values wire speed, arc length, dynamic response
52	_fOption1 ~ _fOption15	float[15]		Extended user-defined options 1~15

Total size: 112 bytes

Defined in: DRFS.h

typedef struct _CONFIG_DIGITAL_WELDING_CONDITION
{
    unsigned char _cVirtualWelding;
    float _fTargetVel;
    float _fMinVelLimit;
    float _fMaxVelLimit;
    unsigned int _nWeldingMode;
    unsigned int _n2t2tSpecial;
    unsigned int _nPulseMode;
    unsigned int _nWMopt1;
    unsigned char _cSimulation;
    unsigned char _cTSopt1;
    unsigned char _cTSopt2;
    unsigned int _nJobNumber;
    unsigned int _nSynergicID;
    float _fWireFeedSpeed;
    float _fArclengthCorrection;
    float _fDynamicCorrection;
    float _fOption1;
    float _fOption2;
    float _fOption3;
    float _fOption4;
    float _fOption5;
    float _fOption6;
    float _fOption7;
    float _fOption8;
    float _fOption9;
    float _fOption10;
    float _fOption11;
    float _fOption12;
    float _fOption13;
    float _fOption14;
    float _fOption15;

} CONFIG_DIGITAL_WELDING_CONDITION, *LPCONFIG_DIGITAL_WELDING_CONDITION;

Note

• Provides a complete digital representation of welding parameters.

• Includes both base process control and up to 15 extended options.

• Commonly used in fully digital power source communication protocols.