You're reading the documentation for an older, but still supported version (1.33.4).
For information on the latest version, please have a look at 1.33.5.

SAFETY_MODE

This enumeration specifies the safety mode of the robot controller (manual, autonomous, recovery, backdrive, measure, initialize). It is used by set_safety_mode, and is defined as follows.

Value	Constant Name	Description
0	SAFETY_MODE_MANUAL	Manual mode
1	SAFETY_MODE_AUTONOMOUS	Auto mode
2	SAFETY_MODE_RECOVERY	Recovery mode
3	SAFETY_MODE_BACKDRIVE	Backdrive mode
4	SAFETY_MODE_MEASURE	Measure mode
5	SAFETY_MODE_INITIALIZE	Initializing mode
6	SAFETY_MODE_LAST	Reserved for the last safety mode index

Defined in: DRFC.h

typedef enum {
    SAFETY_MODE_MANUAL,
    SAFETY_MODE_AUTONOMOUS,
    SAFETY_MODE_RECOVERY,
    SAFETY_MODE_BACKDRIVE,
    SAFETY_MODE_MEASURE,
    SAFETY_MODE_INITIALIZE,
    SAFETY_MODE_LAST,
} SAFETY_MODE;